AVIRE DCP Installationsanleitung Seite 5

SIM CARD UNLOCKING
Important Note: An Avire SIM card doesn't have a SIM PIN code; if the SIM LED is
flashing red, please make sure that the SIM card has been inserted correctly. The SIM
PIN code for other network providers may vary and it can usually be
found on the outer plastic case of the SIM card.
OPTION 1
Disable the blocking PIN code using a conventional mobile phone. Plug the SIM into a
different mobile device and delete SIM PIN code in the device settings.
OPTION 2
You can program the PIN code of the SIM card into the DCP using an analogue phone
plugged into to the J1A or J9 connection (please see page 13 for more details).
Single SIM card version:
Enter DCP configuration mode: wait for DCP voice command
Enter SIM card PIN parameter:
xxxx is the SIM PIN code given by the service provider for SIM0.
Dual SIM card version:
Enter DCP configuration mode: wait for DCP voice command
Enter SIM card PIN parameter:
xxxx is the SIM PIN code given by the service provider for SIM0
yyyy is the SIM PIN code for SIM1 (if installed and required).
Example if only 1 SIM PIN code is required:
If SIM0 PIN is needed - *1# xxxx#
If SIM1 PIN is needed please remove PIN code from SIM1 or install SIM into SIM0 port.
At this point, the SIM card LED (middle LED) will stop flashing red. If it does not, make
sure the SIM is correctly inserted and you have entered the correct PIN.
Important Note: Check ADDITIONAL INFORMATION FOR PROGRAMMING THE DCP
on page 12 for more information.
5