AVIRE DCP Installationsanleitung Seite 14

J10 CONNECTOR - RS-232 or 422/485 Serial Connector
The J10 connector is a standard serial communication port that allows the connection
of computers, controls or any other device that needs remote communication through
a reliable wireless data channel. The connectivity provided by the port is in real time
and acts as a point to point transmitter.
Pin Signal
2 TX Out
3 RX In
5 Ground Ground
J11 - Digital Input/ Output
Pin Function
1
AK1
2 AK2
3 VCC
4
OP1
5 GND
SW1
1
Signal tester
2
3
Reserved
4
Pin Signal
7 RTS Out
8 CTS In
RS-232
Signal
Input Outo-
Coupler
Input Outo-
Coupler
Output 10-21
VDC
Open collector
Mosfet N
Ground
Function
Not used
Activates the CANBus End of Line (EOL) for the CAN
CAN Ω
Default ON – DCP is typically an End of Line device.
Pin Signal
2 T+ T+ RS422
3 R- R- RS422
5 Ground Ground
Description
Inbuilt signal tester
Default OFF
Not used
Avire internal use only
Default OFF
connector.
Pin Signal
7 T- T- RS422
8 R+ R+ RS422
RS-422
14