AVIRE DCP Installationsanleitung Seite 2

ELEVATOR SAFETY
Please follow all Health and Safety rules and take all necessary precautions before
and during installation.
IMPORTANT - This device must be installed by qualified personnel and always in a
restricted area where only such personnel have access. All input and output circuits
of the device are classified as ES2 and cannot be accessible to any end user or
connected to any ES1 or SELV circuit.
SETTING UP THE DCP
Avire SIM cards come activated and ready to be installed. If a non-Avire SIM card is
used, please make sure that the SIM card is activated and unlocked.
1. Open the DCP with a PZ1 screwdriver.
2. Depending on the version of the DCP insert SIM(s) into J4, pushing the SIM(s) until it
(they) click(s). The Dual SIM card version will still work with only 1 SIM installed.
J4
SIM1
SIM0
Dual SIM card
3. Connect the antenna on the DCP to J2 and
ensure it is completely tightened.
NOTE: Only use antennas authorised by Avire.
4. Connect the battery to J3.
5. Wait for the LEDs to turn on. Once the LEDs
turn on, the SIM card will begin to register
with the network which can take 2-5mins.
Having allowed time for the SIM to register,
check the SIM LED to make sure it is green
or amber (check step 10). If it's flashing red
check it's been inserted correctly and then
unlock the SIM card using instructions on
page 5.
6. Check the signal strength by using the built-in network
signal strength scanner. To use the signal scanner
function:
+ Turn SW1 dipswitch 1 to ON (check dipswitch 4 is also ON)
Please refer to pages 13 and 14 for the full picture and connector information
J4
SIM0
Single SIM card
J2
J3
SW1
2