Santec SNC-6302 Kurzanleitung Seite 3

Kurzanleitung / Quick installation guide
SNC-6312IR, SNC-6315IRH, SNC-6323IRH
IP camera sNC-63202, SNC-6312IR, SNC-6315IRH and SNC-6323IRH
To operate the IP dome camera, please follow these steps:
1. Install the camera in the desired location:
Open the camera housing and remove the inner housing and the camera
module.
Fix the housing plate in the desired location using the screws and anchors.
Put the camera module back onto the housing plate.
Lead the cables through the respective openings in the housing and connect
them to the corresponding plugs of the camera module. Connect the camera
to the network using a LAN cable (the network LED lights up in orange when a
network connection is established).
Adjust the lens by putting it in the desired position.
Turn the focus and zoom adjustment rings to obtain a sharp picture while
checking the picture quality in the live view of the camera's web browser.
Put first the inner housing and then the outer housing back on and screw it
tight.
2. Connect the camera to power using PoE (PoE switch or PoE injector required) or
12 V DC / 24 V AC.
3. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
4. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn't work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
Note:
The camera comes with a default IP address:
Default IP address:
User name:
Pass word:
QUICK INSTALLATION GUIDE
192.168.1.168 (or by DHCP, if available)
admin
9999
Version 1.2sfi/1114/dt-engl/A5