Maestro MR904 Bedienungsanleitung Seite 6

Position «0» – «OFF»
Position «1» – «LOW» speed
Position «2» – «MEDIUM» speed
Position «3» – «HIGH» speed
Press the "0" button to turn the device off.
Switching on the "swinging" regime
Press button (8) "swinging" to turn the device on in the swinging regime. Pull the button (8)
up to switch this regime off.
Regulating of the fan case bending
To regulate the fan case bending relative the leg release the adjustment screw by turning
it counter clockwise, place the fan case in the desired position and tighten the adjustment
screw.
Maintenance and care
WARNING!
Before cleaning the appliance in any way, make sure that the appliance plug is not
connected to the socket.
Before cleaning turn off the fan and wait till the blades completely stop.
Never place it in water or any other liquid.
Do not use harsh abrasives, caustic cleaners or oven cleaners when cleaning this
appliance.
If the fan is not very dirty, it is sufficient to wipe its parts with a wet napkin. Protective grid
can be cleaned with a vacuum cleaner and a soft brush.
If the blades are very dirty, frontal grid can be removed and blades washed in warm water
with soft detergent. Do it as follows:
- release the clamps, remove frontal grid;
- remove blades fixation screw;
- remove the blades from the engine shaft;
After cleaning leave the fan details to dry completely. Install the fan details in the reverse
order.
Inside the device there are no details demanding maintenance by the owner. Any other
type of maintenance must be performed by qualified personnel in the service center.
After the season of storage it is recommended to apply 1-2 drops of luboil before use in the
frontal and rear bearing units of the engine. Apply to the specialist of the service center.
Storage
- Before storage unplug the appliance and let it stop completely.
- Clean and dry appliance before storage.
- Its recommend to keep the device is wrapped in a plastic bag.
6