habitat et jardin Sup wave series Handbuch Seite 24

inside the backpack, the SUP is folded together tightly. This will result in severe creasing of the fabric.
Store the SUP in a dry place, either laid out flat or loosely rolled or folded. To prevent damage to the SUP
during storage, do no place any heavy items on top of it. Do not bend the fixed fins on the underside of
the SUP during storage. Under certain circumstances, it may not be possible to return them to their original
shape.To avoid discolouration of the outer skin of the SUP resulting from fouling or polluted water, DO
NOT leave the SUP in water for long periods of time.
Inflation procedure :
1. Choose a smooth surface to assemble your board.
2. Remove the board from the back pack and unroll it.
3. Attach pressure gauge to hose and then attach pressure gauge to pump.
4. Attach other end of hose to the inflation/deflation valve on the rear of the board.
5. Stand the pump on hard, level ground and start to pump. The first time you inflate
the SUP will
require more effort than subsequent inflations.
6. Make sure you keep your hands toward the center of the pump handles when
pumping and your
feet firmly on the footrest of pump.
7. Pump time varies by user but normally takes 3 to 6 minutes.
We recommend using the board at a pressure between 12- 15 psi. 15 psi gives you
the best performance.
The final few PSI is the key to getting the maximum performance from your board.
WARNING: DO NOT USE AN AIR COMPRESSOR. It will result in damage to the
board, and will void all
warranties. Maximum air pressure for this product is 15psi. DO NOT INFLATE
BEYOND 15PSI. Inflatable SUP
boards are not warranted against over inflation.