Procedure
1. Secure the holding plate
⑧
bolts M5
. Use spring washers and normal washers. The tightening torque is
5.7 Nm.
2. Secure the intermediate hinge
⑦
M8x40
and the nut. Use a spring washer and normal washer. The tightening
torque is 24 Nm.
3. Secure the support
⑥
M8x40
and the nut. Use a spring washer and normal washer. The tightening
torque is 24 Nm.
4. Secure the support
5. Align the antenna. To do this loosen the threaded bolts
antenna and then tighten the threaded bolts
Antenna ANT793-8DK
A5E03484060-05, 05/2019
②
to the back of the antenna
③
to the holding plate
④
on the intermediate hinge
④
to the wall with 4 screws via the bore holes
①
with four threaded
②
using the threaded bolt
③
using the threaded bolt
⑥
und
⑥
⑦
und
again.
Installation
⑤
.
⑦
. Position the
31