Assembly /Operation - Superior CB719J-10 Bedienungsanleitung

30526 AERA Vacuum Cleaner D, GB 1/24/07 3:34 PM Page 15

ASSEMBLY /OPERATION

ASSEMBLY
ATTENTION:
Prior to assembly or disassembly of accessories,
please turn the device off and pull the power plug.
• To connect the vacuum hose, insert the connection
nozzle into the vacuum opening of the device. Please
be sure that the connection nozzle snaps into place.
• To remove the vacuum hose, push down on the ribbed
notches on the connection nozzle and pull the vacuum
hose out of the vacuum opening.
• Connect the vacuum tube to the end of the curved
handhold of the vacuum hose.
• The length of the vacuum tube can be adjusted by
using the switch located on the end of the tube. By
pushing the switch down you will loosen the latch, the
tube can now be extended or shortened as needed.
When releasing the switch, please be sure that the tube
will lock in the new position.
• The device is equipped with various attachments
(combination crevice attachment and floor attachment).
These can be exchanged as needed by simply pulling
or pushing the attachment on or off the end of the
vacuum tube.
• A storage compartment for storing the combination
crevice tool is located on top of the rear vacuum
cleaner surface.
• The floor attachment can be adjusted to the surface
texture (carpet or smooth surfaces) by using the
adjustment switch.
Composite
C M Y CM MY CY CMY
OPERATION
ATTENTION:
Never point the device toward humans or animals.
Risk of injury.
• Prior to operating of the device, open the dustbin and
make sure that the vacuum filter bag and the motor
filter are inserted correctly. Missing filters or incorrectly
inserted filters can cause motor damage.
• Lock the dustbin correctly.
• By using the power controls, you can adjust the power
output of your device.
• Pull out a sufficient length of power cord. The yellow
mark on the power cord identifies the ideal length of
power cord. Do not exceed the red mark when pulling
the power cord!
• Insert the power plug into a power outlet.
• The device can be turned on and off by using the
ON/OFF-Switch.
• Minor smoke and odour development is possible during
the first operation. This is normal and will not occur with
repeated use of the product.
• The device is equipped with a moveable carrying
handle, which enables you to carry the device during
operation.
• Always turn the device off by using the ON/OFF-
Switch.
• Then pull the power plug out of the power outlet.
• Push the switch for automatic cable rewind in order to
rewind the power cord. Be sure that the cord cannot be
flung at persons or objects due to the fast speed of the
rewind action. If necessary, position the power plug
near the cable opening prior to rewind and hold on
to it.
• Store the device in a dry location.
15
K
GB