Mounting The Guiding Roller; Mounting The Additional Handle; Operation; Switching On And Off - Parkside PUB 500 B1 Originalbetriebsanleitung

Mounting the guiding
3
roller
1. Insert the guiding roller (11) on to the
motor head (12). It locks into place au-
dibly.
- If using the plastic brush (10), place
the guiding roller (11) into the trans-
port position (21).
- If using the metal/nylon brush
(18/19), place the guiding roller (11)
into the working position (20).
2. Release the guiding roller (11) by
pushing the retaining tab (22) and re-
move the guiding roller (11).
Mounting the additional
4
handle
1. Unscrew the additional handle (14) to
take apart.
2. Insert the additional handle (14) into
the holder beneath the handle (1).
3. Screw the additional handle (14) tightly
using the grip screw (6).
There are several possible latching po-
sitions.

Operation

Caution, risk of Injury!
Always check whether the
device functions correctly be-
fore using it.
Always wear eye protection
when operating the device.
Always unplug the device be-
fore working on it. There is a
risk of injury.
Observe the noise protection and
other local regulations. .

Switching ON and OFF

1. Loop the end of the extension cable
and hang it onto the cable tension re-
lief (5) to ease the tension on the cable.
See detailed illustration
2. Plug the tool into the mains.
3. To turn on, use your thumb to actuate
the switch lock (4), then press the On/
Off switch (2). Release the switch lock.
4. To turn off, release the On/Off switch (2).
There is no continuous operation mode.
The brush will keep rotating for a
few seconds after the device has
been switched off. Keep the brush
away from hands and feet.
Do not try to lock the on/off
switch in place. Do not use the
device if the switch is damaged.
A damaged switch may cause
an injury risk due to the motor
not being switched off after
releasing the on/off switch.

Device adjustments

Length adjustment:
The telescopic arm enables you to adjust the
device to your individual height.
Unfasten the screw sleeve for length adjust-
ment (7). Adjust the telescopic arm (8) to
the desired length and re-fasten the screw
sleeve for length adjustment (7).
Adjusting the splash guard:
You can adjust the splash guard (9) by sli-
ding it backwards and forwards.
GB IE
.
25