Litecraft LPiX.40 Mk2 Bedienungsanleitung Seite 20

During the mounting of the different versions the following advices have to be noted.
LPiX.40 Mk2
LPiX.40 Mk2 can be mount as single strip due to the yoke on the
backside. Only use suitable hooks/clamps approved by the BGV
C1 for this kind of installation. Depending on the unit surround­
ings the yoke can be shifted in an range of +/­ 12 cm to fit to
the surroundings. Make sure that you tighten the screws after
you adjust the yoke.
NOTE!
The connection elements mounted at the sides are only used
for alignment – means the connection of multiple LPiX.40 Mk.2
together. These connection elements are NOT used for static
loads and cannot be used for mounting of LPiX.40 Mk2!
Make sure to safe the fixture by a safety chain which is specified
at least with a load limit of 12 times of the fixtures weight. Only
safety chain with approved connective can be used. Attach the
safety chain through the yoke as well as to the truss system or
similar and safe attachment point. Assure to close the fasteners
as specified.
or a similar and safe attachment point. Assure to close the fas­
teners as specified.
Mounting of optional diffusor
• The delivery of LPiX.40 Mk2 includes two different diffusor.
• Der standard diffusor „frost" can be changed to the diffusor
„black". Lose the side screws of the housing (only one side)
and slide the diffusor out of the housing.
• The mounting of diffusor is made in reverse order.
20
BPiX.160 Mk2
BPiX.160 Mk2 can be mount as single bar due to the yoke on
the backside. Only use suitable hooks/clamps approved by the
BGV C1 for this kind of installation. Depending on the unit sur­
roundings the yoke can be shifted in an range of +/­ 6,5 cm to
fit to the surroundings. Make sure that you tighten the screws
after you adjust the yoke.
NOTE!
The connection elements mounted at the sides are only used
for alignment – means the connection of multiple BPiX.160
Mk2 together. These connection elements are NOT used for
static loads and cannot be used for mounting of BPiX.160 Mk2!
Make sure to safe the fixture by a safety chain which is specified
at least with a load limit of 12 times of the fixtures weight. Only
safety chain with approved connective can be used. Attach the
safety chain through the yoke as well as to the truss system or
similar and safe attachment point. Assure to close the fasteners
as specified.
or a similar and safe attachment point. Assure to close the fas­
teners as specified.
Mounting of optional diffusor
• The delivery of BPiX.160 Mk2 includes two different diffusor.
• Der standard diffusor „frost" can be changed to the diffusor
„black". Lose the side screws of the housing (only one side)
and slide the diffusor out of the housing.
• The mounting of diffusor is made in reverse order.