HQ Power VDLPROM3 Bedienungsanleitung Seite 2

4. Installation
a) Lamps
• Only fit or replace a lamp when the device is unplugged from the mains.
• Only operate the device with a fastened lamp.
• Let a lamp cool down before replacing it as the temperature of a lamp can reach 150°C during operation.
• Do not install lamps with a higher wattage. They get hotter than this device was designed for.
• Replace any deformed or damaged lamp with a lamp of the same type (see "7. Technical Specifications", p.3):
1. Unscrew the front ring, holding the lamp into place.
2. Remove the old lamp and unscrew the wires from it.
3. Fasten the wires to the new lamp, put it in the housing and fix it by fastening the fixation ring.
b) The Pin Spot
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the pin spot is attached should be able to support 10 times the weight of the device for
one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
c) The Mirror Ball and Motor
• The construction to which the mirror ball is attached should be able to support 10 times the weight of the device
for one hour without deformation. It should be able to hold a minimum of 30kg point load.
• The installation must always be secured with a secondary attachment e.g. a safety net.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• The mirror ball has to be connected to the motor via the chain. Make sure the motor is installed perfectly
horizontally. Install it using the metal bracket provided.
• Make sure the rotation of the mirror ball is never hampered and that no side forces can impact on the installation.
• The installation has to be approved by an expert before the device is taken into service.
VDLPROM3 2 VELLEMAN