Installation - WolfVision EYE-10 Bedienungsanleitung

INSTALLATION

With the 1/4" UNC thread, the camera can be mounted onto a tripod.
The UNC-threads can be found on the top and bottom sides.
On the front, a filter/adapter lens can be attached: the M46x0.75. This is helpful i.e. when shorter distances
than the MOD (Minimum Optical Distance, Wide: 50mm and TELE: 500mm) are necessary, a
supplementary lens can be attached.
When the EYE-10 is mounted into a housing (or ceiling) make sure to reserve space for the connected
cables (about 50 to 100 mm, depending on the cable used).
To mount the camera into suspended ceilings, use optional available tile bridge.
IMPORTANT: Please give special attention to the specific country
G
regulations for training and conferencing rooms.
Failure to follow instructions can lead to severe injury!
To avoid possible injury, ensure that the ceiling construction is able to
support five times the required camera weight !
For security reasons we are unable to provide fastening equipment for the ceiling mount with
the camera. We request that you acquire the appropriate fastening material for your particular
ceiling construction at your local hardware store. WolfVision will not take liability if
substandard material is used or the installation is done incorrectly and not according to our
instructions.
ECLIPSE
When the EYE-10 is installed into a housing
(or ceiling) please see the drawing on the right:
U-Shaped Mounting Clip and Ceiling Hangers
The camera is easily mounted to the ceiling with the supplied
U-shaped mounting clip.
In very high rooms, the pick up size will be too large when mounting
the EYE-10 on the ceiling.
If this should be the case, it is recommended using an additional
ceiling hanger and the supplied U-shaped mounting clip to
suspend the EYE-10 further down from the ceiling.
This part should not be covered!
optical
axis
10
top view