Troubleshooting - Progress PAS3100E Benutzerinformation

14 progress
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,

TROUBLESHOOTING

Problem
You cannot activate the appli-
ance or operate it.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
1
MOD.
PROD.NO.
SER.NO
DATA
MODEL
Stick it on Guarantee Card and send
1
this part
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
Problem with the house electri-
cal system.
2
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
MODEL
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth
and some detergent.
3. At the end rub the appliance dry
with a clean cloth.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Examine the fuse in the electri-
cal system of the house in the
fuse box. If the fuses blow
again and again, speak to
qualified electrician.
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
Labels supplied with the accessories
bag
Stick the adhesive labels as indicated be-
low:
3
MOD.
PROD.NO.
0049 SER.NO.
Stick it on Guarantee Card and keep
2
this part
Stick it on instruction booklet
3
Remedy
TYPE
230V-50Hz
IP20