SEVERIN HS 0707 Gebrauchsanweisung Seite 11

∙ Do not use the appliance on pets or
other animals.
Use
Cutting length fi ne adjustment
The side adjusting lever allows smooth
fi ne-adjustment of the cutting length
from approx. 1 to 1.6 mm, even during
operation.
Trimming heads
The push-on combs provided extend the
range of the cutting length. Fit the required
head attachment onto the trimming comb,
pushing it fi rmly down until it is heard
locking into place.
After use, release the attachment at the
back and lift it off.
Trimming heads 3-13 mm
The trimming heads provided allow for
cutting lengths of 3, 6, 9 and 13 mm.
Tapered trimming heads
The tapered trimming heads are designed
for cutting the hair while avoiding a
'stepped' effect.
In this way, the hair above the ears is cut
shorter, while remaining longer towards the
top of the head.
Operation
∙ Before cutting, the hair should be clean
and thoroughly combed fi rst.
∙ When cutting longer hair, use a push-on
comb or cut hair above a normal comb.
∙ Always start with the largest push-on
comb, as this will help you to get a feel
for cutting the hair to the desired length.
∙ For shorter hair-cuts, follow-up with a
smaller push-on comb or without any
comb attachment.
∙ Insert the plug into a wall outlet and turn
the appliance on.
∙ Cut from bottom to top with the trimming
comb lying against the head; lead the
appliance upwards through the hair,
moving it gradually away from the head
at the same time.
∙ The tapered trimming heads are
designed for cutting the hair around
the ears while avoiding a 'stepped'
effect. For the right side of the head,
the attachment marked 'Right Taper'
should be used; for the opposite side
use the one marked 'Left Taper'. Start
trimming from the back of the head and
cut the hair against its natural direction
of growth towards the temples.
∙ For a shaped cut, reverse the appliance
and shorten the hair from top to bottom
without a push-on comb.
∙ Always switch off after use and remove
the plug from the wall socket.
11