Limitations Of Use; Plug Wiring - Frilass E 100 Betriebsanleitung

POWER SUPPLY CABLE
This should be connected as shown
below.
TURBO FAN
This cools the machine as it runs
to prevent overheating.
PILOT LIGHT
This is lit when the machine is
overheatet.
8.0 LIMITATION OF USE
Do not use in following conditions:
1. Outside when raining.
2. Do not use cable reels unless completely unwound and fitted with a thermal
cut-out.
3. Do not use above 140 amp. with 16 amp. fused 230 volt power supply.

9.0 PLUG WIRING

IMPORTANT:
For adequate performance on 230 V you will need a 25 amp. fused supply.
When using a 1-phase 230 V power supply wire the plug as in chapter 9.1. If the
machine is to be operated on a 400 V 3-phase supply connections should be
made as in chapter 9.2.
If in doubt of electrical connections consult a qualified electrician.
9.1 230 V (1-PHASE) CONNECTIONS (E 100, E 145, E 165, E 205)
Use of a 16 amp. plug is only recommended up to a power output of 140 amp. For
use above this amperage consult an electrician.
EARTH
green/yellow
wire
NEUTRAL
blue wire
LIVE
brown wire
18