Technical Characteristics - Ariston KBT 8424 IDO Handbuch

Electrical connection
• The electrical safety of this appliance can only be guaranteed
if the latter is correctly and efficiently earthed, in compliance
with regulations on electrical safety. Always ensure that this
vital safety measure has been taken. If you have any doubts,
call in a qualified technician to check the electrical system
thoroughly.
• The manufacturer denies all responsibility for damage result-
ing from a system which has not been earthed correctly.
• Before powering the appliance, check whether the technical
characteristics featured on the appliance data plate corre-
spond with those of the mains electrical system.
• Check that the current load of the mains supply and of the
power sockets is suitable for the maximum power of the ap-
pliance, indicated on the appliance data plate. If in doubt,
contact a qualified professional.
Disconnect the appliance from the electricity supply before
all operations.
Connect your hob to the electrical system by means of a junc-
tion box: if the appliance is connected permanently to the mains,
an omnipolar circuit breaker, accessible if necessary, with a
minimum contact opening of 3 mm should be installed.
Valid only for models with a power supply cable
Some models are supplied with a single-phase power supply
cable, and should consequently only be connected to the single-
phase mains. Observe the wire colours, as indicated in the dia-
gram attached.
Collegamenti elettrici Tensione Frequenza
FR-BE-AT-DE-GR-ES-IL-
IT-NZ-PT-GP-CH-MA-LU-
IE-FI-SE-IS-GB-NL-DK
230V - 1+N~ 50Hz
CY-MT-AU-NZ-KW
240V - 1+N~ 50Hz
FR-BE-NO
230V - 2 ~ 50Hz
BR=BRUN,BL=BLEU BR=BRAUN, BL=BLAU
BR=BRUIN, BL=BLAUW BR=BROWN, BL=BLUE
* Applicazione del fattore di simultaneità in conformità alla norma CEI
Valid only for models without a power supply cable
Some models are not fitted with a power supply cable, as the
cable should be sized according to the type of electrical connection
in use (see connection table below). To connect the cable, proceed
as follows:
• Using a screwdriver, prise on the side tabs of the terminal
board cover;
• Pull open the cover of the terminal board.

Technical characteristics

Fusibili Sezioni
25A *
2,5 mm²
60335-2-6
To install the cable, proceed as follows:
• unscrew the wire clamp screw and the contact screws.
• to make the desired electrical connection (see table), use the
jumpers housed inside the box. Position the power supply
cable wires according to the indications in the table.
• once the connections have been made, tighten all the terminal
screws fully.
• Fasten the supply cable in place with the clamp and close
the cover of the terminal board.
This appliance conforms with the following
European Community Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
amendments;
- 89/336/EEC of 03/05/89 (Electromagnetic compatibility)
and subsequent amendments;
- 93/68/EEC of 22/07/93 and subsequent amendments;
- 2002/96/EC
The European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of
in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimise
the recovery and recycling of the materials they contain
and reduce the impact on human health and the
environment. The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when you di-
spose of the appliance it must be separately collected.
Consumers should contact their local authority or retailer
for information concerning the correct disposal of their old
appliance.
Warning: If the hob is fitted above a built-in oven, the hob
and the oven must be connected to the mains separately
for safety reasons and to simplify operations when it is
necessary to pull the oven out for some reason.
Electrical connections
1 2 3 4 5
L N
1
L1 L
1
L1 L
1
L1 L L
1
L1 L 1
1
* Application of the simultaneity coefficient in accordance with
cei 60335-2-6 norm
28
Voltage, Fuses,
Frequency Sections
FR-AT-BE-DE-GP--
ES-IE-IL-IS-IT-LU-
25 A*
RE-FI-GB-GR-PT--
2,5 mm²
SE-MA-NZ
230V-1+N~50 Hz
FR-BE-NO
25 A*
2,5 mm²
230V-2~50/60 Hz
FR-BE-CH-DE-AT--
ES-IL-IT-NZ-PT- 16 A*
MA- LU-SE-IS-NL 1,5 mm²
400V2-N~50 Hz
FR-BE-NO
16 A*
1,5 mm²
230V3~50 Hz
NL
16 A*
1,5 mm²
230V2+2-N~50 Hz
CY-AU-NZ-KW-MT
25 A*
2,5 mm²
240V-1+N~50 Hz