VINCENT tubeLine SV-237MK Bedienungsanleitung Seite 35

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "REC OUT" (12) on the back of the appliance to connect an
analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance that is
intended for receiving the unchanged, fixed stereo output level (line level) from the signal source selected
on the amplifier at any given time. The output level is independent of the Volume setting, the Loudness
function and the Tone control (BASS, TREBLE, TONE). Please note that while the preamplifier is muted (18)
the recording output is switched off.
SV-237MK
1 2
Recording device,
e.g. tape recorder
RCA connection
LINE IN
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slightly
alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the "REC"
terminal only for as long as the recording is actually being made.
CONNECTION OF TWO ADDITIONAL
MAIN AMPLIFIER CHANNELS
You only need the "PRE OUT" sockets (13) if you want to use a separate stereo amplifier or two mono
amplifiers to supply two additional loudspeakers. This makes sense if you intend to use two more loud-
speakers for stereo music playback, for example in a separate zone (another room of your home). These
loudspeakers are then connected to the speaker outputs of the additional amplifier(s). The amplifier output
connections "PRE OUT" (12) must be connected with the input connectors of the main amplifier, in most
cases labelled "INPUT", "POWER AMP IN" or "MAIN INPUT".
SV-237MK
1 2
Stereo main amplifier
RCA connection
INPUT
Instead of the stereo main amplifier shown here you can alternatively use two mono main amplifiers.
Vincent
35