Field Of Application - Rock Helmets DYNAMO 397 Bedienungsanleitung

EN

Field of application

Helmet specially designed for industrial use.
The resistance of the chip strap is between 15
and 25 daN (as required by EN 397 regulation).
Instructions for use
This product is part of personal safety
equipment. Read the above documentation
carefully before using the product. Be careful
to read and observe the following instructions
for use. This product is specifically designed for
industrial use (EN 397) and it does not exempt
the user from personal liability for the related
risks. Do not use this helmet in activities for
which it is not designed. Activities carried out
at heights (either sports or industrial) involve
serious risks and danger for the head. Injuries
cannot be ruled out completely. In order to
guarantee the highest level of safety during
such activities, it is necessary to use equipment
in compliance with the current regulations and
to use it properly. The following instructions for
use are important in order to ensure correct
use. However, they cannot replace experience,
personal liability and awareness of individual
users concerning the risks related to industrial
work, such instructions do not exempt from
personal liability due to the related risks. Use
is only permitted to trained and skilled people
or under the supervision of an expert. The
producer denies liability for improper and/
or incorrect use of the product. Liability and
risk rest entirely with the user. In the case of
use in rescue or PPE operations, it is highly
recommended to observe national regulations
on the matter.
Adjustment
In order to assure a safe protection, this
helmet must be adjusted to fit the user's head
dimensions. The helmet must be adjusted to
fit the head properly so that it does not rock
side to side or move when the chin strap is
locked and the slider is in the correct position
based on the head perimeter. The helmet will
only offer the highest level of protection if this
adjustment is done correctly. A perfect and safe
adjustment on the head is guaranteed only if
the chin strap is locked and tightened and with
a correct adjustment to the cranial perimeter.
The straps must not cover the ears and the
buckle must not touch the chin. The locked chin
strap must not exert pressure on the larynx. The
helmet must be adjusted on the head always
in a horizontal position so that it protects the
forehead as well.
1. wear the helmet with the back size adjust
system open
2. lock the size adjust system by rotating the
back wheel
3. lock the chin strap buckle. A locking "click"
must be heard. Tighten the strap so that the
buckle is properly locked
4. adjust the chin strap
5. check the correct position of the helmet and
the correct locking of the systems (buckle and
back size adjust system). If the helmet is worn
correctly, it must not move or rock side to side.
The better the helmet adjustment, the higher
the level of safety.
The fabric inner padding has been inserted
13