Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Since it is not possible to predict every situation or condition that may occur
during cycling, this user manual does not represent a safe use of the bike in all
situations. There are risks associated with the use of any bike which cannot be
predicted or avoided, and which are the sole responsibility of the rider.
•
Additional safety, performance and service information for specific components
such as suspension or pedals on your bike, or for accessories such as helmets or
lights that you purchase, may also be available. Make sure you are informed all
the details of the manufacturers that was included with your bike or accessories.
•
If you have any questions, consult with the bike shop or the manufacturer for the
detailed information.
•
You may ride the bike only after you have carefully read this manual and are
familiar with the product performance.
•
Untrained individual is not allowed to use this product.
•
Before riding, check the voltage meter cable, buttons, and data display.
•
Before riding, check the tire pressure (recommended: 40 - 65 PSI).
•
Wear a helmet when riding and comply with traffic regulations.
•
This bicycle is suitable for riding on paved urban roads. It is not recommended
to ride it on other terrains to avoid danger.
Storage and maintenance
•
It is recommended to use warm water and a sponge to clean the bicycle.
When using special cleaning products, please pay attention to the product's
instructions. Do not use acid, lubricating oil, high-temperature grease, brake
cleaner, or other harsh cleaning products to clean the bicycle.
•
Do not clean the bicycle with high water pressure so as to avoid short-circuiting
the electrical system.
•
Recommended maintenance interval: at least annually after the first 100 miles.
Please check the integrity and condition of the tires and rims, adjust the brake
lines and check the chain drive. Please carefully check whether the following
parts are torqued properly: handle post, saddle, seat post, front wheel, rear
wheel, crank axle nut, pedals.
After 200 to 400 miles, please check the brake pads, chain, sprockets, and rims
for wear an tear. Furthermore, make sure that any bolted parts are properly
tightened.
After every 700 miles, carry out a major maintenance to repair, disassemble,
inspect, clean, and apply lubricating oil. It is recommended to replace
consumable parts such as hubs, pedals, brakes, and gears every 700 miles.
•
When the bicycle comes into contact with water, especially the meltwater with
salt in (In winter, many cities spread road with salt after snowing to prevent
roads from freezing over), clean the bicycle in a timely manner so as to avoid
corrosion of metal parts and aging of painted parts. After the bicycle is used for
a period of time, it should be inspected and adjusted as per the instructions in
11
Werbung
Inhaltsverzeichnis
