Technical Specifications; Maintenance And Cleaning - stayer BHL111 Bedienungsanleitung

gb
4_MAINTENANCE AND SERVICE

MAINTENANCE AND CLEANING

Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position.Unintentional actuation of the On/Off
switch can lead to injuries.
For safe and proper working, always keep the machine
and ventilation slots clean.
When the battery is no longer operative, please refer to
an authorised aftersales service agent for Stayer power
tools.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an aftersales service centre for Stayer
power tools.
TRANSPORT
he contained lithiumion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements. When being transported by third parties
(e.g.: air transport or forwarding agency), special
requirements on packaging and labelling must be
observed. For preparation of the item being shipped,
consulting an expert for hazardous material is required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery
in such a manner that it cannot move around in the
packaging. Please also observe possibly more detailed
national regulations.
DISPOSAL
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-hold
waste!
According the European Guideline 2012/19/EU for
Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that a
re no longer usa-ble must be collected separately and
disposed of in an environmentally correct manner.
Battery packs/batteries:
Li-Ion:
Please observe the instructions in section
"Transport". Do not dispose of battery packs/batteries
into household waste, fire or water. Battery packs/
batteries should be collected, recycled or disposed of in
an environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2006/66/CE.

TECHNICAL SPECIFICATIONS

= Battery
= Voltage
= Battery power
= Battery charging time
= No load speed
rpm
= Tightening torque
= Percussions
ipm
= Wood drilling capacity
= Steel drilling capacity
= Stone drilling capacity
= Weight
= Sound power level
L
PA
= Sound pressure level
L
WA
= Vibration
The values given are valid for nominal voltages
[U]230/240 V-50/60 Hz - 110/120 V - 60Hz. For lower
voltage and models for specific countries, these values
can vary.
INFORMATION ON NOISE AND VIBRATIONS
Wear hearing protection helmets!
Measured values established in accordance
with EN 62841-1.
The technical specifications indicated here are
understood within certain tolerances (in accordance with
the standards currently in force).
- 18 -