Getting Started; Time Setting - Levenhuk Wezzer PLUS LP30 Bedienungsanleitung

Getting started

Base station
• Open the battery compartment cover (6) and insert 3 batteries according to the correct
polarity. Close the cover.
• Wait until the indoor temperature is displayed on the base station.
Sensor
• Open the battery compartment cover (8). The sensor should be operated on channel 1.
• Insert 2 batteries according to the correct polarity. Close the cover.
• To re-establish the sensor connection manually, press RESET using a pin.
Sensor connection
• Place the base station and the remote sensor within the effective transmission range. Ensure
that the channels are assigned after you set up the power supply for the base station and all
the sensors.
• If the reception is successful, the display will show the temperature of the respective
outdoor sensor. If the values are not received from a channel, "—" appears on the display.
Check the batteries and try it again. Check if there is any source of interference.
• When changing batteries, replace the batteries first in the base unit, and then in all the
sensors, to re-establish the connection. If an adapter supplies power to any of the devices,
briefly disconnect the power to that device when replacing the batteries. If you change
the batteries only in one of the devices (for example, in the sensor), the signal may not be
received correctly.
• If you have problems in receiving the readings, make sure that channel 1 is selected on the
sensor, and then press and hold CH on the base station for 5 seconds.
• The effective range may differ depending on the unit's position. Due to interference (various
remote control devices, etc.), the maximum distance between the base unit and the sensor
may be significantly reduced. In such cases, we suggest moving the base unit and sensor a
little. Sometimes it is enough to move one of these units a few inches!
NOTE! Although the sensor is weather resistant, never place it in direct sunlight or
in the rain or snow.

Time setting

Press the SET button and hold it for 3 seconds. The digits that are to be set are flashing. Press UP
or DOWN to change the value, and then press SET to continue.
The setting order: Hours > Minutes > Year > Month > Date > Temperature unit.
Finally, press the SET button to save the settings and exit.
The language and the selected abbreviations for each day of the week are shown in the following
table.
Language Monday
English, EN MON
Weather
Temperature
Press the UP button to switch between °C and °F.
Weather forecast
1. Sunny
2. Partly cloudy
3. Cloudy
4. Rainy
5. Snowy
Tuesday Wednesday
TUE WED
1 2
Thursday Friday
THU FRI
3
3
Saturday Sunday
SAT SUN
4 5