Low Battery Indicator - Levenhuk Wezzer PLUS LP20 Bedienungsanleitung

Alert function
Press the CH/▲ button until an arrow is displayed next to the desired channel. Then, press and hold
the ALERT button for 3 seconds. The digits that are to be set are flashing. Press ▲ or ▼ to set the
desired value limit.
The setting order: temperature upper limit → temperature lower limit → humidity upper limit →
humidity lower limit.
To activate the alarm, press the ALERT button once again when the digits are still flashing.
Finally, press the ALERT button to save the settings and exit. To stop the alarm, press any button.
NOTE! The temperature and alert icons will still be flashing until the temperature is back
to normal.
To turn off the alert function, press the ALERT button, and then press and hold it again for 3 seconds
to enter the alert setting of the channel where the arrow is located. Now, press and hold the ALERT
button until the alert is off.

Low battery indicator

If the low battery indicator is displayed for either the outdoor sensor or the base station, immediately
change the batteries.
Weather
Temperature/humidity
• Press and hold the MEM/▼ button to switch between °C and °F.
• Press the ALERT button to display the high/low temperature and humidity alert.
Climate indication
Too cold
The climate indication is a pictorial indication based on indoor air temperature and humidity in an
attempt to determine the comfort level.
Trend arrow indicators
Rising
The temperature and humidity trend indicator shows the trends for the forthcoming few minutes.
Arrows indicate a rising, steady or falling trend.
History record
• Press the MEM/▼ button to display the MAX./MIN. temperature and humidity.
• To clear the history records, press and hold the MEM/▼ button for 3 seconds.
Comfortable
Steady
7
Too warm
Falling