Connect The Router - Cisco Systems LINKSYS WRT54G Schnellinstallationsanleitung

There are two ways to configure the Router. Choose one of the following:
• Run the Setup CD-ROM - It is strongly recommended that you use the
Setup CD-ROM. Insert the Setup CD-ROM into the CD-ROM drive, and
follow the on-screen instructions.
•Use this Quick Installation guide - If you wish, you can use the Router's
Web-based Utility. Proceed to Step 1 of this Quick Installation.
1

Connect the Router

A
Power down your network
devices.
B
Locate an optimum location
for the Router. The best place
for the Router is usually at the
center of your wireless network,
with line of sight to all of your
mobile stations.
C
Fix the direction of the
antennas. Normally, the higher
you place the antennas, the
better the performance will be.
D
Connect a standard Ethernet
network cable to the Router's
Internet port. Then connect the
other end of the network cable
to your broadband modem.
E
Connect your computers or
Ethernet devices to the
Router's numbered ports using
standard Ethernet network
cabling.
2
All manuals and user guides at all-guides.com
D
E