Startup / Operation - BOMANN GB 7246 Bedienungsanleitung, Garantie

Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the blind cap (1) and the hinge cover (2).
• Dismount the upper door hinge (4) by loosening
the screws (3). Open the appliance door a little
and lift it out of the lower door hinge.
• Place the appliance door safely aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (7+8).
• Dismount the lower door hinge (5) by loosening
the screws (6).
• Displace and attach the door hinge (5) at the op-
posite appliance side. Turn in the feet (7+8) ac-
cordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Displace and attach the upper door hinge (4) at
the opposite appliance side.
• Insert in the blind cap (1) at the opposite hole and
put on the hinge cover (2) again, which you have
removed at the beginning.
screw wrench, Phillips screw-
Check if the door is aligned vertically and horizontally
optimally so that the smooth opening and closing of
the door is guaranteed.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control at the back of
appliance. See also the section "Settings".
Settings
The power levels [1 – 5] regulates the different val-
ues of the internal temperature. Turning the tempera-
ture control clockwise will lower the inside tempera-
ture.
Setting 1:
Lowest setting (warmest inside temperature)
Setting 5:
Highest setting (coldest inside temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
18