User Maintenance - Herschel MANHATTAN 3000 Installations & Bedienungsanleitung

CAUTION:
The power switch may become unintentionally switched to position I (Remote Bypass)
during unpacking and installation. To avoid any possibility of burns, ensure the power switch is in the
OFF position (marked O on the switch) before switching on mains power.
Position I. To bypass the remote control, turn the switch on the heater to position I. When the switch is in
this position the heater will turn on or off depending on whether it has power to it. The remote control unit
will not control the heater when the switch is in position I. Use this where you wish to hard wire the heater
to a switching device such as a push button timer or thermostat.
Position II. To use the heater with the remote control, ensure the switch of the heater is switched to
position II.
Insert 2 x AAA Alkaline batteries into the remote control.
The remote control operates the heater remotely on or off with adjustable heat level and timer described
below. All Herschel remote controls have the same frequency, so it is possible to control several heaters
with just one remote.
There may be odour or vapour from the heater on initial use or if it has not been used for an extended
period. This is normal.
OPERATION BY REMOTE CONTROLLER:
The heater may be operated from the remote control supplied.
Button
All Herschel remote controls have the same frequency, so it is possible to control several heaters with just
one remote.
EXTENDED USE:
Over time the grill may discolour due to high temperatures, airborne contaminants and fingerprints.
Discolouration will not affect the performance or safety of the heater and is not a condition for warranty
replacement.

USER MAINTENANCE:

Avoid touching the front grill on the front of the heater and be sure to wipe off fingerprints from these parts.
Avoid touching a cold lamp with your fingers. Always wipe off finger marks if you accidentally touch the
lamp. Residue from fingerprints can cause hot spots on the lamp surface and shorten the life of the lamp.
Function (Heater On)
1 Turns heater on or off
2 Increase Heat Level or
Timer hours
3 Decrease Heat Level or
Timer Hours
4 Enable Timer adjustment
Enable Heat Level
5
adjustment
Remote Control Function
Function (Heater Off)
Turns heater on to
Level 1 (minimum)
Turns heater on to
Level 2(Maximum)
0 - 24
ENGLISH
LED Display on Heater
L1 50%
L2 100%
[0H] - [24H]
L [n]