Initial Use - Herschel MANHATTAN 3000 Installations & Bedienungsanleitung

INSTALLATION:
Diagram 3: Bracket Assembly
Using the brackets as a template, mark and drill 4 x 8mm holes in the wall. Insert the plugs into the wall and
fit the brackets, washers, spring washers and nuts over the exposed threaded ends. Tightening the nuts will
force the plug end to expand in the wall and form a secure mounting for the heater.
Fit the opposite bracket to the back of the heater before then inserting and tightening the bolt and nut for
each hinge.
HANDLING WHILE INSTALLING:
Take care while installing to avoid touching the grill on the front of the heater. Be sure to wipe away any
finger marks from the heater before the heater is first switched on, since the oils in fingerprints can burn
and cause rapid discolouration of certain parts.
CAUTION:
•
Ensure mains power is OFF and the unit is cool before commencing installation.
•
The supplied mains cable must not contact the top surface of the heater during operation.
•
Heater must not be located immediately above or below a socket outlet. Electrical connections must
be made outside of the footprint of the unit to avoid heat build-up in the connection.
•
Joists, beams and rafters shall not be cut or notched to install the appliance.
•
This heater is not intended for recessed installation.
•
The identification mark and model reference should be visible after installation.
•
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
•
Ensure that wires are properly secured and cannot be pulled by small children.

INITIAL USE:

The power switch on the side of the MANHATTAN has 3 positions:
•
Position O (Off)
•
Position I (Remote bypass)
•
Position II (Remote control).
Mounting Hardware Includes:
4 x bracket pieces - fit together to form 2 brackets
with a central pivot. The protruding blade on each
bracket fits over the circular end of the opposing
bracket to ensure the correct pivot angle.
4 x M6x60 masonry expansion bolts (for fitting
brackets onto wall).
2 x small bolts to fit brackets onto the rear of the
heater.
2 x small bolts and wing nuts (to form the pivot on
the brackets).
ENGLISH