Electrical Information - Herschel MANHATTAN 3000 Installations & Bedienungsanleitung

11. All operators shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children shall not plug in,
switch on or regulate the appliance or perform user maintenance including cleaning.
DO NOT
12. leave the heater operating unattended.
NEVER
13. place hands under the heating element during operation.
IMPORTANT:
14.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
Herschel MANHATTAN is rated to a standard IP54. Suitable for outdoor use.
Installation in areas such as outdoor bathrooms, pools or hot tub areas must be carried out by a suitably
qualified installer and comply with local electrical safety requirements.
If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, damage or injury caused or
resulting from inadequate fitting or incorrect placement of heaters close to water sources.

ELECTRICAL INFORMATION:

The Herschel MANHATTAN may be plugged in to a waterproof socket. Any extension lead used must have
sufficient capacity to carry the current required by the heater as show in in Table 1. All plugs, sockets and
switches intended for use outdoors must have an appropriate water ingress protection.
Alternatively the plug can be removed and the unit connected to fixed mains wiring. Fixed wiring
installations must only be carried out by competent persons or a qualified electrician according to national
regulations and the unit must be earthed. The electrical supply to the unit should be provided by connecting
to a current protection device suitable for the electrical rating of the unit in accordance with Table 1 and
providing disconnection in both poles. All fixed wiring must have sufficient capacity to carry the current
required by the heater.
Always disconnect the heater from the power when not in use.
Herschel recommends you use a Type C circuit breaker to handle the initial current when the heater is
switched on.
Table 1. Electrical Specification
Model
Voltage
Rated Power
Current
Breaker
Frequency
Cable Colour
The mounting position of the unit must ensure that any mechanical damage to the flexible cable is unlikely.
Excess cable should be secured and must not touch hot parts of the heater and should not encroach into
the heated area. Do not allow the cable to act as a conduit for water into the cable gland on the back of the
Ensure supply voltage does not exceed 245 Volts.
MANHATTAN 3000
220 – 240V
3000 Watts
12.5-13.7 Amps
Type C recommended
50 Hz
Brown, Blue, Yellow/Green
ENGLISH