Oase Filtoclear 3.000 Gebrauchsanweisung Seite 31

Connection at water inlet
Push the union nut onto the black spiral stepped hose adapter.
Push / twist the hose on and secure with a hose clip.
Insert the flat seal into the union nut and screw tight onto the
water inlet nozzle:
Connection to water outlet
Push the union nut onto the transparent spiral stepped hose
adapter. Push / twist the hose on and secure with a hose clip.
Insert the green flow vane into the union nut and screw tight onto
the water outlet nozzle.
Note: We recommend diverting the cleaned water via a small
watercourse, for example, instead of feeding it directly back into
the pond. This enriches the water with additional oxygen.
Connecting to cleaning connection
You can have a drainage hose permanently connected to the
cleaning connection. This allows you to drain the dirty water
directly into the sewerage system or onto a flower bed.
Important!: When the Filtoclear is being used in 'filter' mode, the
cleaning connection or any drainage hose connected to it must
always be sealed with the sealing cap and inserted flat seal in order
to prevent the pond from emptying. At the same time the sealing
cap acts as a safeguard in case the function switch is accidentally
set to 'Clean'.
To connect the drainage hose, push the union nut onto the
transparent spiral stepped hose adapter. Push / twist the hose
on and secure with a hose clip. Insert the green flow vane into the
union nut and screw tight onto cleaning connection. In order to be
able to seal the open end of the drainage hose with the sealing cap,
you need to push / twist the black spiral stepped hose adapter with
thread onto the hose and secure it with a hose clip. Screw the
sealing cap and inserted flat seal on tight.
Instruction for use
31