Herunterladen Inhalt Inhalt Diese Seite drucken

elo ASC18-2.7 Anleitung Seite 13

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Instructions for Use
Before you use your pressure cooker for the first time, wash and rinse it thor­
oughly in hot water and dry immediately.
Please inspect the bottom of the cookware and the hob for any remaining
dirt, adhesive labels and unevenness. Moving the cookware around may cause
damage. We recommend lubricating the rubber seal with a little cooking oil to
make opening and closing the lid easier. To ensure that the correct pressure is
produced in the cooker to speed up the cooking process, the pot must contain
a minimum quantity of liquid (water, stock, etc.). If you are preparing a dish
which generates a lot of froth, the pot must be no more than half­full.
Tips for energy-saving cooking
To save valuable energy when cooking, please bear the following in mind:
• Ensure that the base of the pot has a larger diameter than the hot plate, and
not vice­versa; this can save up to 15% energy.
• Always use the cooker with the lid on, this saves up to 20% energy.
• Make use of the after­heat of electrical hot plates. Switch them off approx­
imately 10 minutes before the cooking process is finished. This can save up
to 10% energy.
Cooking zone diameter:
Cookware diameter:
Induction/effective diameter:
Ø
18,0 cm
Ø 18,0/22,0 cm
Ø 14,0 /18,0 cm
24
Closing the Pressure Cooker
Please check the safety devices before
Silicon seal
closing the pressure cooker.
The pressure regulating valve opening (see fig.
2) must be clean and the safety valve must not
be jammed. You can check this by pressing your
finger on the safety valve stopper on the under­
fig. 4
Safty valve
side of the lid (see fig. 4).
If you are able to press the stopper in, this means that the safety valve is work­
ing properly. If the stopper does not respond to the pressure and is jammed, it
must be loosened and cleaned, as described on page 28. Place the lid on the
cooking pot so that the marking on the
cooker handle (black dot) is aligned with
the marking on the lid (silver dot) (see
fig. 5). Then press the lid down slightly
and turn it until both handles are on top
of one another and you hear the release
button click into place.
Check to see that the lid is correctly
locked and that the release button is in
the rear position (see fig. 6). When the
nib of the release button can no longer
be seen, this means that the lid is cor­
rectly locked. The pressure cooker is now
properly closed.
Abb. 5
fig. 5
Closed position
fig. 6
25
UK

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Asc18-3.2Asc22-3Asc22-4Asc22-6Asc22-7

Inhaltsverzeichnis