Operation; Safety; Initial Use; Switching On - Beurer HD 150 XXL Cosy Taupe Gebrauchsanleitung

4. Operation

4.1 Safety

CAUTION
• The heated overblanket is fitted with the SAFETY SYSTEM. This electronic sensor technology
provides protection against overheating across the entire surface of the heated overblanket with
an automatic switch-off if there is a fault.
• Please note that, for safety reasons, the heated overblanket can no longer be operated after a fault
has occurred and must be sent to the specified service address.
• Do not connect the defective heated overblanket with another control of the same type. This would
trigger a permanent switch-off via the control safety system.

4.2 Initial use

• First, connect the control to the heated overblanket by inserting the plug-in
coupling.
• Then plug the mains plug into the socket.

4.3 Switching on

Set the sliding switch (3) on the right side of the control to the setting "I" (ON) – see image of control.
When switched on, the temperature settings display is lit up (5).

4.4 Setting the temperature

To increase the temperature, press the
Level 0: OFF
Level 1: minimum heat
Setting 2 - 5: individual heat setting
Level 6: maximum heat
NOTE
The fastest way to warm up the heated overblanket is to initially set the highest temperature setting.
WARNING
If the heated overblanket is being used over several hours, we recom-
mend that you set the lowest temperature setting on the control to avoid
the body overheating and thereby any potential burns to the skin or heat
stroke.

4.5 Automatic switch-off

This heated overblanket switches itself off automatically after 3 hours. The temperature settings display
flashes after the blanket is switched off.
To switch on the heated overblanket again, first set the side ON/OFF sliding switch on the control to the OFF
(0) position for 5 seconds. After about 5 seconds it is possible to switch it on again.

4.6 Switching off

To switch the heated overblanket off, set the sliding switch on the side of the control to setting "0" (OFF).
The temperature settings display is no longer illuminated.
NOTE
If the heated overblanket is not in use, set the slide switch on the side to ON/OFF to level "0" (OFF)
and pull the mains plug out of the socket. Then disconnect the control from the heated overblanket
by unplugging the plug-in coupling.
button (4). To decrease the temperature, press the
13
button (4).