Troubleshooting - Lehner Versand ZHQ2566-RMLED-C Bedienungsanleitung

The remote control

Press on the I/O switch to activate the heater

Press " " for the first time, the product will work with one heating tube.

Press " " a second time, the two heating tubes of the product work at the same
time.

Press " " for the third time, the heating tube stops working.

Touch " " for the first time, the LED light works

Touch " " a second time, the LED light turns off.

When the product is working, press "
hours
Note: The working method between touch switch and remote control is slightly different.
", and the product will be scheduled for 2
MAINTENANCE
Unplug the unit and let it cool completely.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You
may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes
to clean the heater. This may cause damage or deterioration to the surface of the
heater.
Although this heater is outdoor approved, DO NOT immerse the heater in water for
your safety.
The light source of this luminaire is not replaceable; when the light source reaches its
end of life the whole luminaire shall be replaced.
Wait until the unit is completely dry before use.
STORAGE
If the heater will not be used for a long period of time, store it in a cool, dry location when
not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.
TROUBLE SHOOTING
If the heater will not operate, please check the following before seeking repair of service:
Check if the power cord is plugged into an electrical outlet, if not plug in.
Check if electricity to the main fuse is working.
Make certain the power switches are turned on. If not, choose a setting.
Technical specification
•
Power supply 220-240V 50-60Hz
•
Wattage 2500W
•
Insulation class I
5