Lehner Versand ZHQ2566-RMLED-C Bedienungsanleitung Seite 19

Minimum required distances:
a) 50cm from the side wall
b) 50cm from the ceiling
c) Installation height above 180cm
Follow the below steps to install the heater:
Step 1: Take out the lifting chain from the parts bag, put one end into the mounting hole
on the product hoist ring (see picture), and put the other end into the fixed ceiling.
Step 2:Take out the cable tie from the parts package, and tie the power cord to any
lifting chain (as shown in the picture)
D. Plug the Patio Heater into a grounded 220-240V 50-60Hz 13A power outlet
OPERATING INSTRUCTIONS
WANRING: The heater must be properly installed before it is used This unit is equipped with
one heat setting On I Off.

Plug the Patio Heater into a grounded 220-240V 50-60Hz power outlet.

Press on the On/Off switch to the "I" position to activate the heater.
Touch switch
Press " " the first time:
Switch on the heating tube on the left side of the product.
Press " " the second time:
Switch on the heating tube on the right side of the product.
The heating element on left side turns off.
Press " " for the third time:
The two heating tubes of the product will work at the same time.
Press " " for the fourth time:
2 heating tubes switched on, and LED lights working at the same time.
Press " " for the fifth time:
Both heating elements are turned off, and the LED light is working alone.
Press " " for the sixth time, and the product enters into the standby state.
4