INTEZZE PIKO 3 Bedienungsanleitung Seite 4

ON/OFF
ATTENTION! Fully charge the earphones together with the case prior to first use.
The earphones turn on automatically when you pull them out of the case (a
confirmation tone sounds in both of them). Likewise, they switch off
automatically when stored back in the case. They also turn off automatically
after two minutes when they are not connected to any device.
Manual switch on
Hold down both touchpads for about 3 seconds until the power-on tone sounds.
Manual switch off
Hold down both touchpads for about 5 seconds until the power-off tone sounds.
Pairing
Prior to the first use with every device, it is necessary to pair the earphones. The
next time you use the same device, pairing is no longer necessary and it connects
automatically when you pull the earphones out of the case.
Pairing procedure
1) Remove both earphones from the case and wait a few seconds for both of
them to turn on (one of the earphones will flash alternately red and blue).
2) Turn on Bluetooth on your phone and look for Intezze PIKO 3 in Available
BT Devices. Confirm pairing.
3) Successful pairing is confirmed by a tone and the flashing LED turns off.
EN