Jeep ADVENTURER Benutzerhandbuch Seite 19

Brake lever adjustment
2xe ADVENTURER / 2xe URBAN CAMOU
Brake adjustment
2xe ADVENTURER / 2xe URBAN CAMOU
INSTRUCTIONS
It is possible to adjust the position
of the brake lever, if necessary, by
unscrewing the screw (A). Once the
position has been adjusted, tighten
the screw (A).
INSTRUCTIONS
If the brake is too tight or too loose,
use the Allen wrench to loosen
the screw (A), then adjust the
brake cable, (shorten the brake
cable at the top if it is too tight; if
it is too loose, pull the brake cable
downwards) and then, retighten the
screw (A).
Check the correct alignment
between the brake caliper and the
disc. Use the screws (B) and (C) to
adjust the position / alignment on
the disc, if necessary.
18