Werbung
Verfügbare Sprachen
Verfügbare Sprachen
B. SETUP VARIATIONS
D. ADJUST BASES
The distances between the rubber rests can be adjusted
to the dimensions of the instrument. Just push the rubber
rests to the front until the correct distance has been
selected.
Keyboard "large"
Keyboard "small"
TECHNICAL DATA
Tubes, struts: Steel, powder coated black
Screws, nuts, U-disks: Steel, galvanized
Material
Locking pin: Steel, nickel plated
End caps, rubber rests/top:TPE, shore 59A
Handle, disk, caps: PA, PE
Load
max. 40 kg
Example: Height 620 x width 780 mm
Dimensions
Support tubes: ø 30 x 350 mm; Base tubes: ø 30 x 500 mm
Packaging
Box: 1020 x 520 x 102 mm
Weight
4.3 kg
Accessories
Carrying Case 18959-000-00, Stacker 18941-000-55
All manuals and user guides at all-guides.com
E. TIPS on how to secure the keyboard
OK:
- centered
- adequate
-
overlap
NOT OK:
- does not
-
overlap enough
-
overlaps too much
- not centered
C. DIMENSIONS
Transportation setting (cardboard packaging)
OK:
Overlap
adequate
NOT OK:
Overlaps too much
NOT OK:
Not centered
NOT OK:
Overlaps too much
CHECK, MAINTENANCE, CLEANING
In the event of workstation maintenance pay attention to possible risks
(the stand is bumped into, pinching/ wedging). To care for the product
use a damp cloth and a non-abrasive cleaning agent.
FAULT FINDING (F) & REMEDY (R)
F: Stand is not stable:
F:
B: Adjust balance end caps, check surface.
F: Height/width of the stand does not fit:
F:
B: Select a different hole in the disk.
F: Keyboard is not firmly placed on the stand (unstable):
F:
B: Check the bottom of the keyboard for uneven surfaces.
F:
B: Adjust the width of the stand.
F: The keyboard is not placed on the rubber rests:
F:
B: Adjust the back rubber rings to the proper position.
OK:
Centered
Overlap
adequate
OK:
Centered
NOT OK:
Overlaps too much
NOT OK:
does not overlap
enough
OK:
Werbung
