Werbung
Verfügbare Sprachen
Verfügbare Sprachen
18940 Keyboard stand
with patented »Smart-Lock« quick release push-button system for:
- unsurpassed quick setup, adjustment and collapsing
- great for on the road use: uncomplicated, robust and space saving
- the central steel disk provides seven settings ranging from seated to
standing - the transport setting provides the smallest possible footprint
- with typical K&M quality features such as:
-
solid workmanship, high quality surface coating, anti-slip rubber tray
-
surface protection, rubber slip resistance caps, and balancing end caps for uneven surfaces
- With the option to stack a second keyboard (18941 Stacker)
- Height/width are universally adjustable; Base Tube: ø 30 x 500 mm,
-
Top Tubes ø 30 x 350 mm, Weight: 4.3 kg
Thank you for choosing this product. The instructions provide directions to all of the important set up and
handling steps. We recommend you keep these instructions for future reference.
SAFETY NOTES
- Load bearing weight max 40 kg.
- Be sure that the surface will bear the load and is suitable and level.
- The fact that the product is collapsible and adjustable, can result in the risk of pinching/wedging of hands.
-
Careful and attentive handling during setup, operation, and disassembly is indispensable.
- Prior to attaching the instrument, be sure that the bolt is properly clicked into place 4.
- Ensure that the weight on the stand is centered, and select the proper setting width (refer to Section: TIPS)
- The end caps are made of high quality material and to the extent possible free of softening agents.
-
To protect particularly delicate floors (possibly certain wood floor types) a slip resistant pad should be used, if needed.
SETUP INSTRUCTIONS
1 Setup the stand, such that both top tubes (350 mm) are on top
1
and the feet tubes (500 mm) are on the bottom.
2 Press the green knurled button, to release the locking pin.
3 Pull the support arms apart until the desired height/width has
3
been reached.
3
Now let go of the green knurled button to allow the pneumatic
3
locking pin to slide into the proper drill hole.
3
If required, both tube frames may have to be moved a bit to
3
facilitate this.
4 NOTE: Please ensure that the locking pin
4
is properly in place. The bolt sticks out about
4
2 mm from the hole disk.
5 In the case of uneven surface adjust the balance
5
end caps accordingly (+/-).
350 mm = top tubes
ca. 2 mm
projecting
500 mm = feet tubes
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18940-017-55 Rev.03 03-79-277-00 5/17
All manuals and user guides at all-guides.com
locking pin
locking pin
engaged
not engaged
USAGE NOTES / FUNCTIONS (A-E)
A. ADJUSTMENTS
The hole disk is comprised of
7 holes i.e. adjustment options.
This provides a wide range of
different (heights and widths)
to support the keyboard stand.
See Section SETUP OPTIONS
NOTE
Form and size of the locking
pins and the distance between
the holes in the disk were
consciously chosen, to provide
the keyboard stand high weight
bearing capacity and stability.
Holes closer together would have
given the stand a greater range of
setup options but it would have been
at the cost of stability.
Werbung
