First Time Use - iStorage diskashur DT2 Schnellstartanleitung

All manuals and user guides at all-guides.com

First Time Use

To setup the diskAshur DT , insert the supplied USB cable to the back of the drive and connect to your computer.
2
Next, connect the supplied AC adapter to the back of the drive and a mains power outlet. Once connected press the
power switch on the back of the drive to the ON position, your diskAshur DT
all security components are working properly each time the diskAshur DT
through 3 test stages, blinking in sequence RED,
RED (Standby State) on a successful test. Any test failure will force the diskAshur DT
automatically resume the self-test without affecting the security characteristics or any data stored on the drive.
With your diskAshur DT powered on and connected, follow the instructions in the table below to unlock with the
2
default Admin PIN for the first time.
Instructions - first time use
1. Connect the diskAshur DT
Standby State
2. In Standby State (solid RED
hold down 'UNLOCK + 1' buttons
3. Enter the Admin PIN (default - 11223344)
and press 'UNLOCK' button
4. Press the 'UNLOCK' button once again to
unlock diskAshur DT and access drive contents
2
Note: Once the diskAshur DT
and in a solid state and will only blink when data is being transferred. It can be locked down
immediately by pressing the 'LOCK' button once or by
the 'Safely Remove Hardware/Eject' icon within your operating system.
4
GREEN and BLUE, followed by two
LED
to a USB port -
2
LED), press and
has been successfully unlocked, the
2
undergoes a rapid self-test to verify
2
is powered on. The LEDs will go
2
GREEN blinks and then to
to securely reset itself and
2
LED State
RED LED will be solid awaiting PIN entry
Solid RED LED will change to blinking
GREEN and BLUE LEDs
GREEN and BLUE LEDs blink rapidly
together for a few seconds then to a
solid GREEN and finally a solid
indicating the diskAshur DT
Mode"
Solid BLUE LED will change to a blinking
GREEN, and finally a solid
indicating the diskAshur DT2 is unlocked
GREEN LED will remain on
(strongly recommended) clicking
BLUE LED
is in "Admin
2
GREEN LED
4