Faber HIGH-LIGHT BK MATT KL A91/2 Gebrauchsanleitung Seite 6

4. CONTROLS
L
Key Key
pressing
L Short
Long with light or
motor on
Long with
loads off (motor
and lights)
T1 Short
Long with light
on
Long with
loads off (motor
and lights)
T2 Short
Long with light or
motor on
6
T1
Function
The lights alternate between high intensity, medium intensity (if
present) and off.
If there is an induction hob coupled to the hood, if the hood is off, as
soon as the induction hob is switched on, the hood lights are switched
on at maximum intensity.
Delay Function
It activates/deactivates the Delay function (automatic shutdown of the
Motor and function of lighting delayed by 30').
Cannot be activated with Intensive or 24h on.
all K-Link pairing
Before starting the procedure, follow the specific instructions in the
manuals of the devices to be paired.
The procedure for pairing the hood with K-Link compatible devices
(induction hob or remote control) starts. Up to 3 induction hobs and a
single remote control can be associated. Reference should be made
to the manual of the devices for the operations that must be per-
formed on these.
The pairing process takes 2 minutes. If no device is recognised within
this time, check that the procedure for the devices to be paired has
previously been started. It is possible that the maximum limit of asso-
ciable devices has been reached.
Turns the motor on/off at the first speed.
Activates/Deactivates the Activated Carbon Filters alarm.
all
K-Link Depairing
The procedure for deleting all K-Link compatible devices previously
associated with the K-Link Pairing function starts.
Turns the motor on/off at the second speed.
24h function
Activates/deactivates the motor in 24h Air Exchange mode, a speed
that allows suction of 10 minutes every hour, for a 24-hour cycle.
It cannot be activated if the Intensive or Delay mode is active.
T2 T3
S1
T4
LED
-
Flashing
LED T1 and T2 flashing:
pairing procedure
progress.
Upon successful com-
pletion of the procedure,
LEDs T1 and T2 are
switched on
seconds.
Fixed
All the LEDs flash twice:
alarm activated.
All LEDs on for 1
second:
alarm deactivated.
Upon successful com-
pletion of the procedure,
LEDs T1 and T2 flash 5
times.
Fixed
Flashing
in
for 2