Bellman & Symfon CARQ-BE1411 Benutzerhandbuch Seite 73

Installation – hardwiring your doorbell
1 Pull the battery tab to start the transmitter. Within 2 min, press the lower button
10 times to turn off the internal mic. The LEDs will blink 3 times to confirm.
2 Remove the front cover to access the screw terminal. There are 3 connection points:
 Use 1 and 2 to connect an active switch, like a relay with current
(2–30VDC, polarity independent or 2–24VAC, 5 - 150Hz).
 Use 2 and 3 to connect a passive switch, like a push button.
3 Put the front cover back, remove the protective film from
the Velcro and mount the door transmitter on the wall.
1
x10
139
2
3
Ext. trig
Ext. trig
Optimizing the doorbell detection
The next step is to teach the transmitter to recognize your doorbell.
1 Press and hold button 1 until the top LED start to blink. Release it to
start the recording.
2 For door buzzers: Press and hold the doorbell for at least 8 seconds.
For door chimes: Press the doorbell at least 8 times.
3 Press button 1 on the transmitter to stop the recording. If the LED lights
up in red, you need to repeat steps 1 and 2. If you have an intercom, use
button 2 and follow the steps above to record its sound.
1 2 3
Grön: OK
Green: OK
Röd: Ej OK
Red: Not OK
140