Bellman & Symfon CARQ-BE1411 Benutzerhandbuch Seite 18

Installation – intercom and mechanical doorbell
If you have an intercom and a mechanical doorbell, you may need two signal-
ling system - sound detectors, i.e. one for each sound source.
1 Pull the battery tab to start each signalling system - sound detector. Clean the
wall surface with the wet wipe and remove the protective film from the Velcro.
2 Mount one of the signalling system - sound detectors to the left of the
doorbell and the other to the left of the intercom's speaker, as close to the
sound sources as possible.
Max 3cm Max 3cm
1 2
29
,1.2"
2
Mechanical Mechanical
Max 3cm Max 3cm
doorbell doorbell
Optimizing the doorbell detection
The next step is to teach the detector to recognize your doorbell.
1 Press and hold button 1 until the top LED start to blink. Release it to
start the recording.
2 For door buzzers: Press and hold the doorbell for at least 8 seconds.
For door chimes: Press the doorbell at least 8 times.
3 Press button 1 on the detector to stop the recording. If the LED lights up
in red, you need to repeat steps 1 and 2. Following the same steps, you
can use button 2 to record the sound of your intercom.
,1.2"
1 2 3
EN
Grön: OK
Green: OK
Röd: Ej OK
Red: Not OK
30