Texi HESTIA Bedienungsanleitung Seite 33

TEXI HESTIA
IRONING BOARD
PROBLEM
The board does not warm up or
venvlavon does not work
The board cover gets wet while ironing
The board "leaks" water a•er ironing
If a•er all these controls the appliance does not work properly, it is advisable to apply directly to one of the Authorized Service Centers.
Only Authorized Service Centers have the technical knowledge and stock of original spare parts needed to guarantee efficient and
safe servicing.
To ensure that the reliability and safety of your products remain unaltered in vme, please request and use only original spare parts
and accessories available from Authorized Service Centers.
CAUSE
The general on/off switch (21) on the unit
is off
No power is supplied to the socket of
power supply
Too much steam is used
The board is svll cold
The iron soleplate drips
Sucvon funcvon is not used enough;
The board is not used properly
SOLUTION
Switch on (21)
Check that power is supplied by plugging in
another electrical appliance
Reduce steam; too much steam does not
make ironing easier
Wait for the board to warm up
A few drops of water are normal when
you start ironing; increase iron
temperature
Use sucvon when steam surge is used
Follow the instrucvons at the beginning
of the paragraph
EN