Commissioning; Maintenance; Releasing The Signal Isolator; Dimensional Drawing - Camille Bauer SIRAX SI 815-6 Betriebsanleitung

7.1 Plugging the module into the backplane
Before inserting the SIRAX SI 815 into the
backplane, ensure that, ...
... the backplane wiring is in strict accord-
ance with the wiring diagram of the
module
... the backplane is coded correctly
according to the section entitled "Me-
chanical coding of the backplane".
Read the instructions for the back-
plane.
1. Clip the module base onto the top-hat rail.
2. If the backplane is mounted vertically, turn the quick
release screws on the module to a vertical position,
respectively if it is mounted horizontally, turn the screws
to a horizontal position.
3. Press the quick release screws inwards with the screw-
driver until there is an audible click.
1.
Fig. 8. Plug the module into the base.

8. Commissioning

The device is in operation as soon as the input signals E1
and E2 are connected.

9. Maintenance

The signal isolator requires no maintenance.
All manuals and user guides at all-guides.com
2.
3.

10. Releasing the signal isolator

1. Rotate the quick release screws 90°.
2. Withdraw the plug-in module.
1.
Fig. 9. Withdraw the module from the base.

11. Dimensional drawing

150.7
135.7
Fig. 10. SIRAX SI 815 in housing B17.
2.
+0
15 18
– 0.5
15