Air Filter - LG GSLV91MCAD Bedienungsanleitung

global_main.book.book Page 42 Friday, September 17, 2021 10:39 AM
MAINTENANCE
42
4
Tighten the screw cap until the colored line in
the water filter is no longer visible.
5
Press and hold the Water Filter button for
three seconds. That resets the Replacement
Filter icon. The new water filter has been
activated.
6
Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
*1
Push fit connector type
1
Remove the screw cap.
2
Pull the pipe out from the water fitler.
3
Push the pipe into the water fitler, making sure
the end is fully sealed.
4
Insert the screw cap until the colored line in the
water filter is no longer visible.
5
Press and hold the Water Filter button for
three seconds. That resets the Replacement
Filter icon. The new water filter has been
activated.
6
Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
CAUTION
• Failure to replace filters when required or using
non LG authorised water filters can cause the
filter cartridge to leak and result in property
damage.
Application Guidelines/Water
Supply Parameters
• Service Flow: 1,9 lpm
• Water Supply: Community or Private Well -
Potable Water
• Water Pressure: 138 - 827 kPa
• Water Temperature: 0,6 - 37,8 °C
• Capacity: 1 892 litres

Air Filter

Reusing the Air Filter
You can re-use the air filter by removing odors
from the air filter.