Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setup wizard
When your Evoke is turned on for the first time, it runs through a setup wizard to configure settings for date/
time and network. Once this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu >System settings > and select the required settings
option(s). To run the setup wizard again, select Menu > System settings > Setup wizard.
The Network settings can be reset later by manually running the Network wizard, select Menu > System
settings > Network >Network wizard .
Select Yes to start the setup wizard. If you choose No, a second screen asks if you would like to run the
wizard next time your Evoke is started; select Yes or No. The system then starts without configuring
time/date and network settings and enters the Main Menu.
Note: If power is removed while the wizard is in progress, the wizard will run again next time your
Evoke is started.
Network
Your Evoke is compatible with all common network protocols and encryption methods, including Wi-Fi
Protected Setup (WPS).
To connect your Evoke to your network, you need a Wi-Fi wireless router, together with password key if
set.
SSID
[WPS]My network
Other network 1
Other network 2
Other network 3
Other network 4
Select 'Network wizard' , and then select a network from the list.
If the network is open (non-encrypted), your Evoke connects and no further details are required;
see Completion below.
Password protected network
Key:
0
1
2
7
8
9
,
f
g
h
m
n
To enter the network's key (password), use the Navigation Arrows to highlight the next relevant
character and press to select each character in turn.
Backspace, OK and Cancel are included to the right of the password screen. These can be
accessed just using the Navigation Arrows.
*
3
4
5
6
BKSP
OK
.
_
-
@
CANCEL
a
b
c
d
e
i
j
k
l
o
p
q
r
s
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
