Product Overview (Fig. 1); Control Panel Overview (Fig. 2); Disassembling And Cleaning Before First Use - Philips HR2375 Bedienungsanleitung

Introduction
Congratulations on your purchase, and welcome to Philips!
To fully benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
Product overview (Fig. 1)
Mixing chamber lid
a
Safety switch hole of the mixing
b
chamber lid
Power cord
c
Disc holder safety switch
d
Main unit
e
Shaping disc storage
f
Water/flour cup
g
Cleaning brush
h
Control panel overview (Fig. 2)
On/off button
a
Display
b
Start/pause button
c
Disassembling and cleaning before first use
1 Remove the mixing chamber lid. (Fig. 3)
2 Loosen the front panel control knobs.
Note: The front panel is heavy. Take extra caution when removing it.
3 Disassemble the front panel, the shaping disc, the shaping disc holder, the mixing paddle,
and the mixing chamber in order.
4 Clean all detachable parts, and wipe them dry.
Assembling
1 Push the mixing chamber into the appliance. (Fig. 7)
2 Point the mixing paddle to the hole in the main unit. Insert the mixing paddle all the way
into the main unit. (Fig. 8)
3 Attach the disc holder onto the appliance.
4 Put the shaping disc onto the disc holder , and make sure it is firmly fixed on the disc
holder. (Fig. 10)
Note: Make sure the inner cavity of the shaping disc and disc holder is properly fitted. (Fig. 11)
Pasta cutter
i
Front panel knobs
j
Front panel
k
Shaping disc
l
Disc holder
m
Disc holder safety switch lever
n
Mixing paddle
o
Mixing chamber
p
Extrusion only button
d
Automatic button
e
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 9)
ENGLISH
5