Operation - Teesa TSA8037-2 Bedienungsanleitung

16
1. Before using the heater, make sure it is placed on a flat and stable surface.
2. Insert the plug of the heater's power cord into a suitable power mains socket.
3. Press the Power button on the front panel to turn on the heater to standby mode (88 is
displayed).
4. The MODE button should be:
• pressed once to show last set temperature.*
• pressed for the second time to enter AUTO OFF timer.
• pressed for the third time to enter AUTO ON timer.
• pressed for the fourth time to set high operation mode.** If this setting is maintained,
the heater will continue to operate in the high setting until manual closure or the
room temperature exceeds 30°C.
• pressed and held to set middle operation mode. If this setting is maintained, the
heater will continue to operate in the middle setting until manual closure or the room
temperature exceeds 30°C.
• pressed and held again to set low operation mode. If this setting is maintained, the
heater will continue to operate in the low setting until manual closure or the room
temperature exceeds 30°C.
5. Use the + / - buttons to set the required temperature within the range from 13°C to 30°C.
Note: If the temperature is not set, the heater will operate continuously.
6. When room temperature reaches set temperature, the heater will turn off.
7. When the room temperature is lower than the set temperature, the heater is turned on
again.
* The device saves the last set temperature. 24°C is set as a default.
** High operation mode is set as a default.
Timer
Auto off
Use this function if you want the heater to operate for a certain period of time (from 1 to 24
EN
hours) and then automatically turn off.
Note: Set the desired temperature before setting the timer so that the heater will turn on and
off to maintain set temperature and then turn off completely at the set time.
If the temperature will not be set, the heater will operate continuously until the time of
automatic shutdown (time of automatic shutdown is set to 10 hours by default).
1. Press the MODE button twice to enter auto off timer- hour digits are displayed, timer
icon and AUTO OFF flash.
2. Use the + and – buttons to set the timer. Once the timer icon stops flashing, the timer is
activated.
3. When the set time is up, the heater will automatically turn off.

OPERATION

Owner's manual