Safety Instructions - AIT HDI 11K400/230 KB Gebrauchs- Und Wartungsanleitung

Use and maintenance manual

1. Safety instructions

This manual describes the operation of the unit and the precautions to be taken for
your safety.
Read it carefully before use and keep it in a safe place for future reference.
These instructions must be read and understood before use.
Do not undertake any modifications or maintenance other than those specified in the
manual. The manufacturer shall not be held liable for physical or material damage due
to improper use of the equipment
In case of problem or doubt, please consult a qualified person to use the unit correctly.
The safety instructions must be observed.
The manufacturer declines all liability in the event of improper or hazardous use. Any
use not mentioned in this manual is strictly forbidden and potentially dangerous.
This machine should only be used for the purpose for which it was expressly designed,
that is: to generate heat inside ferrous materials.
Any other use not expressly covered in this manual is strictly prohibited as considered
improper and therefore dangerous. The machine is semi-automatic and therefore
requires the presence of an operator.
The operator has the direct responsibility for compliance with all safety standards not
only where he is concerned but also for any persons who may be exposed to machine
risks.
Do not use the unit if the power cord or plug is damaged.
Caution! Very hot surface. Risk of burns.



In case of burns, rinse with plenty of water and seek medical advice immediately.



Danger from gases and vapours.






Overheated objects and equipment can cause burns.
Do not touch hot objects with bare hands.
Wait for the objects and equipment to cool down before using them.
Machine use should only be entrusted to adult, suitably trained personnel in
full compliance with current regulations and the instructions contained in the
manual.
Remove any jewellery and/or metal object before using this unit.
Keep the machine in a suitable place, protected from weathering.
Keep away from fumes and do not breathe vapours.
When working indoors, ventilate the room and/or use an air extractor to
evacuate vapours and gases.
Induction heating of certain materials, adhesives and fluids can produce
vapours and gases. Breathing these gases and vapours may be dangerous
to your health.
If ventilation is insufficient, use a certified respirator.
Read the product technical and safety data sheets (MSDS) and the
manufacturer's instructions for adhesives, metals, coatings, detergents, and
pickling agents.
Do not use the heater on degreasing or spraying parts. Heat can react with
vapours to form highly toxic and irritating gases.