Werbung
Declarations of Conformity
Concerning Safety and Electromagnetic Compatibility
Manufacturer's Name:
Manufacturer's Address:
Material Designation:
Year of Manufacture:
I, the undersigned, Serge Olivier,
Declare that I have received the assumption of the above material, used and installed in accordance with the notice, with
the essential requirements of Directives 73/23/CEE and 89/336/CEE, modified by 92/31/CEE and 93/68/CEE by the applica-
tion of the following regulations:
EUROPE: Norway Only: This product is designed for IT power system with phase-to-phase voltage 230V. Earth grounding
is via the polarized, 3-wire power cord.
FI: "Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan"
SE: "Apparaten skall anslutas till jordat uttag"
NO: "Apparatet må tilkoples jordet stikkontakt"
Full name:
Title:
Date:
FCC Statement (For U.S.A.)
Federal Communications Commission Radio Frequency Interferences Statement
Pebble model conforms to the following specifications: FCC Part 15, Subpart A, Section 15.107(a) and
Section 15.109(a) Class B digital device.
Supplemental information:
This equipment has been tested and finds to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference's by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by Evolis
Card Printer may cause, harmful interference and void the FCC authorization to operate this equipment.
VCCI (For Japan)
This equipment complies with the Class B category for information technology equipment based on the rules of Voluntary
Control Council for Interferences by Information Technology Equipment. When used in a residential area, radio interferen-
ce may be caused. In this case, the user may be required to take appropriate corrective actions.
Evolis Card Printer
29, avenue de la Fontaine
Z.I. Angers Beaucouzé
49070 Beaucouzé, France
Pebble 3
2004
EN 60950-1 of 2001
EN 55022 Class B of 1998
EN 55024 of 1998
EN 61000-3-2 of 2000
EN 61000-3-3 of 2000 +A1 of 2001
Serge Olivier
Technical Manager
September 2004
Signature:
Werbung
