Care And Cleaning - Bellman & Symfon BE1470 Benutzerhandbuch

Technical information
Dimensions and weight H 86mm (3.4") x W 57mm (2.2")x D 29mm (1.1"). Weight: 70 g (2.5 oz.) incl. battery
Power supply
Mains power: 7.5 V DC 1500 mA via the BE1260 charger accessory
Battery power: 1 x 1.5 V AAA alkaline or 1 x 1.2 V AAA NiMH rechargeable battery
Power consumption Active: ≤ 220 mA, Idle position: ≤ 1 mA
Operating time Alkaline battery ~ 2–3 weeks, NiMH battery ~ 1week, fully charged
Activation Via Visit transmitter
Radio frequency 314.91 MHz, 433.92 MHz or 868.3 MHz depending on region
Coverage 50 – 250m (55 – 273yd) depending on radio frequency. Coverage is reduced by
walls, large objects and other radio transmitters.
Accessories BE1260 Pager charger, BE1270 Bed shaker
In the box BE1470 Pager, Belt clip, safety cord and an extra front label
Environment For indoor use only.
Regulatory
Fulfils CE, FCC & IC, RCM, Der Grüne punkt
Additional information
Operating temperature 0° – 35° C, 32° – 95° F
Transport and storage temp. -10° – 50° C, 14° – 122° F
Relative humidity 15% – 90% (non condensing)
Maintenance and cleaning Maintenance free. Clean with a dry cloth. Don't use household cleaners, aerosol
sprays, solvents, alcohol, ammonia, or abrasives.
Warranty and service If the product appears to be damaged or doesn't function properly, follow the
advice in this booklet. If it still doesn't function properly, contact your retailer for
info about obtaining warranty service .
109 Installer's guide

Care and cleaning

Please note: Failure to follow these care and cleaning instructions could result in damage to the
pager and void the warranty.
Using connectors and jacks
Never force a connector into a jack. Check for obstructions on the jack. If the connector and jack don't join
with reasonable ease, they probably don't match. Make sure that the connector matches the jack and that you
have positioned the connector correctly in relation to the jack.
Using the pager
Operate the pager in a dry environment where the temperature is always between 0° and 35° C (32° and 95° F).
If the pager gets wet, it should no longer be regarded as reliable and should therefore be replaced.
Cleaning
To clean the pager, use a soft, lint-free cloth. Avoid getting moisture in openings. Don't use window or household
cleaners, aerosol sprays, solvents, alcohol, ammonia, or abrasives.
Service and warranty
If the pager appears to be damaged or doesn't function properly, follow the instructions in this user guide
If the pager still doesn't function as intended, contact your local dealer for information on service and
warranty.
Additional information
For information about the proper disposal of the pager, and for other important safety and regulatory
compliance information, see the section Important safety instructions on the following page.
Installer's guide 110