Advanced Programming - Bellman & Symfon BE1470 Benutzerhandbuch

Changing the radio key
If a neighbor also has a Visit system, you can change the radio key so that your systems don't interfere.
The radio key is changed on the transmitters and must be set to the same positon on all units in the system.
Here is how you change the radio key
1 Open the transmitter cover and move any radio key switch/es to the up=on position
to change the radio key. See the transmitter user manual for further information.
2 Press and hold the function button on the pager until the green and yellow LEDs
blink alternately. Release the button.
3 Press the test button/s on the transmitter within 30 seconds to send the new radio key.
4 All Visit LEDs blink 5 times to show that the radio key has been changed. It then returns to normal mode.
1 2
105 Installer's guide
On
Off
3 4
x 5

Advanced programming

By using advanced programming, you can customize the signal pattern from a specific transmitter and event,
displaying the LED colour and vibration pattern of your choice. The advanced programming overrides the
radio key and pairs the units via the serial number. Please note that smoke alarms cannot be programmed for
safety reasons.
Note: The transmitter must be activated as it is intended to be used in the system to generate the right signal.
This means that you can't always use the transmitter test button, see Default signal pattern for the relevant
transmitter.
Here is how you program the pager:
1 Press and hold the function button on the pager. The green and yellow Visit LEDs will start to blink
alternately. While still holding down the button, activate the desired transmitter as intended.
The yellow battery LED on the pager will light up to indicate that you are in advanced programming mode.
Release the button.
2 Scroll through the different Visit LED options by pressing the function button on the pager. Select the desired
Visit LED pattern by holding down the function button until the battery LED goes out and lights up again.
3 Scroll through the different vibration options by pressing the function button on the pager. Select the desired
vibration pattern by holding down the function button until the battery LED goes out and lights up again.
4 The pager will now show the new Visit LED colour and vibration pattern. Press the function button briefly to
end the demonstration. After a short while, the pager will return to normal mode.
Installer's guide 106